|
If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
Datasheet File OCR Text: |
DC/DC Converters TES 3 Series, 3 Watt compliant RoHS Features SMD Package Wide 2: Input Voltage Range I/O Isolation 500VDC Under Voltage lockout Operating Temp. Range -40C to 7C Short Circuit Protection High Accuracy of Pin Co-Planarity Lead free Design - RoHS compliant 3 Years Product Warranty UL 60950-1 The TES-3 series is a family of high performance 3W dc-dc converter modules featuring wide 2:1 input voltage ranges. The 15 models come in a low profile molded SMD package with dimensions of 32.3 x 14.8 x 10.2 mm. A high efficiency allows an operating temperature range of -40c to 71C at full load. This product is qualified for soldering in a high temperature lead-free reflow solder process. Typical applications for the converters are battery operated equipment, instrumentation, communication and industrial electronics, everywhere where an isolated, tightly regulated voltage is required. Models Ordercode TES 3-20 TES 3-2 TES 3-22 TES 3-222 TES 3-223 TES 3-240 TES 3-24 TES 3-242 TES 3-2422 TES 3-2423 TES 3-480 TES 3-48 TES 3-482 TES 3-4822 TES 3-4823 36 - 75 VDC 8 - 36 VDC 9 - 8 VDC Input voltage range Output voltage 3.3 VDC 5 VDC 12 VDC 12 VDC 15 VDC 3.3 VDC 5 VDC 12 VDC 12 VDC 15 VDC 3.3 VDC 5 VDC 12 VDC 12 VDC 15 VDC Output current max. 700 mA 600 mA 250 mA 125 mA 100 mA 700 mA 600 mA 250 mA 125 mA 100 mA 700 mA 600 mA 250 mA 125 mA 100 mA Efficiency typ. 75 % 79 % 82 % 81 % 81 % 76 % 80 % 83 % 82 % 82 % 76 % 80 % 83 % 82 % 82 % http://www.tracopower.com Page of 4 DC/DC Converters TES 3 Series Input Specifications Input current no load /full load 12 Vin models: 20 mA / 300 mA typ. 24 Vin models: 5 mA / 150 mA typ. 48 Vin models: 3 mA / 75 mA typ. 12 Vin models: 6 VDC / 8 VDC typ. 24 Vin models: 12 VDC / 16 VDC typ. 48 Vin models: 24 VDC / 32 VDC typ 12 Vin models: 25 V max. 24 Vin models: 50 V max. 48 Vin models: 100 V max. 0.5 A max. can be reduced by ext. 1-2.2 F polyester film capacitor Pi filter 1% - Input variation Vin min. to Vin max. - Load variation 10 - 100 % single output models: dual output models balanced load: dual output models unbalanced load: 0.3 % max. 1.0 % max. 1.0 % max. 2.0 % max. 50 mVpk-pk max. 0.02 % / C > 110% of Iout max., continuouse hiccup mode, indefinite (no automatic recovery) - single output models - dual output models - Operating - Case temperature - Storage 470 F 180 F -40 C ... +71 C +100 C max. -40 C ... +125 C 95 % rel H max. >1`000`000 h @ 25 C 1`500 VDC 65 pF typ. >1`000 Mohm 300 kHz typ. (frequency modulation PFM) UL 60950-1, EN 60950-1, IEC 60950-1 CSA File No. 226037 http://directories.csa-international.org - Input/Output - Input/Output - Input/Output 3 Watt Start-up voltage / under voltage shut down Surge voltage (1 sec. max.) Reverse voltage protection Reflected input ripple current Input filter Output Specifications Voltage set accuracy Regulation Ripple and noise Temperature coefficient Current limitation Short circuit protection Capacitive load General Specifications Temperature ranges Humidity (non condensing) Reliability, calculated MTBF (MIL-HDBK-217E ground benign) Isolation voltage (60 sec.) Isolation capacity Isolation resistance Switching frequency Safety standards Safety approvals All specifications valid at nominal input voltage, full load and +25C after warm-up time unless otherwise stated. http://www.tracopower.com Page 2 of 4 DC/DC Converters TES 3 Series Physical Specifications Case material Package weight Reflow soldering profile non conductive black plastic (flammability to UL 94-V0) 6 g (0.21 oz) peak temp. 245C (10 sec max.) 217C for 90 sec. max. convection reflow solder process is recommended 3 Watt Outline Dimensions mm (inches) 32.3 (1.272) S Seating Plane Detail A 10.2 (0.402) 0.5 (0.02) 14.8 (0.583) 16.1 (0.634) 18.8 (0.740) 24 13 Top View Pin-Out Pin 2 3 1.0 (0.04) Single -Vin (GND) -Vin (GND) NC NC NC NC +V Output NC -V Output NC +Vin (Vcc) +Vin (Vcc) Dual -Vin (GND) -Vin (GND) NC Common NC -V Output + V Output NC Common NC +Vin (Vcc) +Vin (Vcc) 1 2.16 2.54 (0.1) 12 17.78 (0.7) (0.085) 0 2 3 4 5 22 23 24 Detail A M10:1 .0 4) 1. 0 (0 0.15 1.3 (0.051) http://www.tracopower.com 0.15 (0.006) Tolerance: 0.25mm 0.010] 0.05mm (Pin's) [0.002] Page 3 of 4 DC/DC Converters TES 3 Series Solder Pad Dimensions mm (inches) 3 Watt 27.94 (1.1) (0.085) 2.16 2.54 2.54 (0.1) (0.1) 17.78 (0.7) 2.54 2.54 (0.1) (0.1) 20.0 (0.787) 1 (0.059 Min.) 1.5 Min. Specifications can be changed any time without notice. Rev. 09/06 Jenatschstrasse 1 * CH-8002 Zurich * Switzerland Tel. +41 43 311 45 11 * Fax +41 43 311 45 45 * info@traco.ch * www.tracopower.com 2.8 (0.11) Page 4 of 4 |
Price & Availability of TES3-1210 |
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |